Balaclava is of heavy quality, absorbs moisture well and has a good...
Balaclava is of light quality, absorbs moisture well and has a good...
For all your Honda GX160/200 or Loncin parts you are at the right place!
Subcategories
Does not fit with the current UT2 engine!
Bearing on the drive side (engine) and in the oil bath clutch.
Bearing for oil bath clutch (outside) and crankshaft bearing GX270 (output side).
Clutch friction disc (cover disc) suitable for Honda GX120 wet clutch up to 270.r
Clutch hub for Honda wet clutch. Fits only crankshaft with 20mm diameter.
Clutch disc (steel) suitable for oil bath clutch Honda GX120 to GX270.
Pressure plate (4-pin pad) suitable for Honda GX120 to 270 wet clutch.
Spring for pressure plate suitable for oil bath clutch Honda GX120 to 270.
Retaining plate for clutch spring suitable for Honda GX120 to 270 wet clutch.
Coupling weight (1 piece) suitable for Honda GX120 to 270 wet clutch.
For standard crankshaft GX 160 UT2. Not suitable for the older GX160 K1 / U1 / UT1 and GX200 engines.Complete with screws.
For standard crankshaft GX 160/200 K1 / U1 / UT1. Does not fit the current GX160 UT2.Complete with screws
Shaft 20mm.For Honda engine GX 160 SHQ4 / RHQ4
Voor oliebadkoppeling aan het motorrondsel GX160 tot 270.En voor krukas GX 340/390.
Cylinder head is without valves, without valve springs, without rocker arms, without rocker bolt.
Cylinder head is without valves, without valve springs, without rocker arms, without rocker bolt.
For engine crankcase cover GX160 / 200 and coupling housing GX270.
Diameter: 28 mmRecording flexible tube: 44/40 mmFor engine: Honda GX160/200
Valve guide for exhaust valve Honda GX 140/160/200. NOTE: These are "undersize" valve guides. The valve guides must be gripped after fitting to the dimension of the valve!In addition, the valve seat must always be reworked when valve guides have been replaced.
Gasket between engine and oil bath clutch on Honda GX120, GX160, GX200.
Gasket for the clutch / crankcase cover on the Honda GX120, GX160, GX200
Gasket for the clutch / crankcase cover on the Honda GX120, GX160, GX200
Cylinder Head Gasket for Honda GX 200 and GX160UT2 (newest model)
Sealing ring for oil dipstick and oil filler neck.
White plastic dipstick for the oil bath clutch Honda GX160 / 200
Red metal case (without inner workings) for recoil starter.
Valve guide for intake valve Honda GX 140/160/200. NOTE: These are "undersize" valve guides. The valve guides must be gripped after fitting to the dimension of the valve!In addition, the valve seat must always be reworked when valve guides have been replaced.
Fits Honda GX 120 to 390 original carburettor.
On / Off switch sitting in the fan cover (Japanese production).Fits Honda GX120 / 160/200 K1 / U1 / UT / UT2 And for Honda GX240 / 270/340/390 K1 / U1 / UT1. With the current UT2 motors, this switch does not fit!